Bosch – OM-1


More details

Similar Products

allen-heath-sq-dante
  • Allen & Heath

Allen & Heath – SQ Dante V2 Card

SQ Dante V2 provides any SQ mixer or AHM processor with a full 64x64 channel, 96kHz or 48kHz interface to a Dante network. An SQ fitted with the Dante option card can seamlessly connect to amplifiers, preamps and other devices on the Dante network.The SQ Dante V2 card can be switched between 96kHz or 48kHz to accommodate Dante networks running at either sample rate. In addition to facilitating system integration, the card also enables digital splits and affordable multitrack recording direct to a computer.
    Dante Interface Cards
wohler
  • Wohler

Wohler – OPT-DANTE (12G)

Installing a Wohler unit with the Dante hardware option into an existing and functioning Dante network is virtually plug and play. The rear panel AoIP jack supports 1Gb/s and 100Mb/s Ethernet devices in Dante Audio over IP network configurations. Channel source selections are made by choosing Input Type ‘AoIP’ in the Configuration-Configure Presets page regardless of which AoIP option is installed. The iAM-series unit is set up at the Wohler factory to be used as a slave rather than a master within the Dante network. Other devices or software, such as a Dante Controller, are expected to be responsible for most device configurations and all audio routing.

    Dante Interface Cards
DMI-DANTE-64-96-Flat-1-1200x750
  • DiGiCo

DiGiCo – DMI-DANTE64@96

The DiGiCo DMI-DANTE64@96 allows 64 channels in and 64 channels out at both 48kHz and 96kHz. It has a Primary and a Secondary port, both of which are Ethercon ports, and an RJ45 Control port. The card has two modes that can be changed in Dante Controller. In Switched Mode, the three ports are switched together. In redundant mode, the Control and Primary ports shall be switched together and work as a redundant pair with the Secondary port, each having separate IP addresses so that if the primary connection fails, the secondary connection will take over.

    Dante Interface Cards