← Back to Product Catalog

Stewart Audio – FLX80-4-CV-D

More details

Product Information

4 Channel DSP-Enabled Amplifier 4 x 80W @ 70/100V Dante™ Network Enabled

The FLX-E-80-4-CV-D is a 4 channel, 70V/100V, 1/2 rack amplifier delivering 80W per channel with built in DSP, Ethernet control & reporting, secondary RS-232 control and remote volume control. The FLX-E-80-4-CV-D amplifier supports Dante™ audio.

Onboard DSP for signal routing and filtering
Ethernet configuration, control & reporting
Pre-mix level control
4 analog inputs (4 line/mic; 2 w/ phantom power)
4×4 Break in/Break out Dante™ channels

Similar Products

ev-tg7|ev-tg7

Electro Voice

Electro-Voice – TG7

3500 W per channel power amplifier. 3500 W per channel power amplifier.

High-power performance for top-level tours
Rugged, lightweight package
3500 W per channel (2 Ω)
Grounded Bridge Class-H design
Switch-mode power supply
Microprocessor-controlled
Front LCD panel for operation-mode setup and monitoring
Slot for optional RCM-26 IRIS-Net-compatible DSP and control module
11-level protection package
Only 32 lbs (14.5 kg)

Amplifiers

See the product

CMX - Power amplifier with DSP & Dante

CMX

CMX – DSP-4500

The CMX DSP-4500 is a power amplifier with DSP and Dante.

4 x 60W power amplifier
100V, 70V, 4 Ohm & 8 Ohm output with selectors
Built-in DSP with EQ, gain control, crossover, delay, limiter, high-pass filter & low-cut filter
Dante network control with 4 In 4 Out matrix
Two Ethernet RJ-45 network connector for both Dante and DSP configure
Remote GPIO for failure outputs
1U height 19” rack mount type power amplifier
Balanced line input by phoenix connector for four channels.
Each four inputs with separate gain control.
Separate four channel indicators for protection, clip, input and output.
Complete short circuit, overload, high temp, clip and DC protection.
Dante increases connectivity flexibility, and provides the freedom to use the amplifier power away from the source, wherever it is needed. It also enables the models to allow mixed inputs using either digital or onboard analog audio connections

Amplifiers

See the product

Biamp

Voltera – D-1200-8

8-channel amplified loudspeaker controller, 1200 watts total power. Key Features

Audio DSP and amplified loudspeaker controller plus some headroom for Tesira custom processing and hosting of expanders
4 class D channels sharing 1200 watts
Power sharing provides up to 50% of total power or 1200 W through any single channel
High peak voltage output capability: 145 Vpk
Each channel can drive low impedance (2.7, 4, 8, and 16 ohm), 70V, or 100V
Each model supports AVB, Dante, and AES67
Accurate raised cosine EQ below 160 Hz
Group-controlled raised cosine EQ making it attractive for tuning large systems
Comprehensive amplifier limiter scheme avoids protective mutes and shutdowns
Processor can be sustained through POE – no main power required and no reboots
Support for failover-to-analog from networked audio input operation
5-year warranty
Compliant with the US Trade Agreement Act (TAA)
Biamp Workplace Ready

Amplifiers

See the product