DiGiCo - A168D Stage

DiGiCo – A168D Stage

Product Information

The A168D Stage is a portable 16 input 8 output I/O Expander, again using the Dante network protocol to provide additional I/O anywhere on a network. It comes with 16 mic preamps on XLR inputs with Phantom Power status LEDs and 8 XLR line outputs with direct preamp control from the 4REA4 controller software. It runs at 48k and 96k and is AES67 compatible. Primary and secondary ports again come with locking EtherCON connectors and can run in redundant or switched mode.

Specifications

Dante Ch: 16x8
Bit Depth: 24-bit
Sample Rate: 48kHz, 96kHz
AES67 Enabled

Blustream – PRO-IN4HDA

The PRO-IN4HDA board features 4x HDMI 2.0 inputs supporting 4K 60Hz 4:4:4 that can be independently routed to any HDMI/HDBaseT output board. Each HDMI input includes independent 2ch Dante audio breakout, fixed level 2ch analogue audio breakout, and 4x 2ch Dante audio inputs allowing audio embedding onto the HDMI source. The PRO-IN4HDA features quick release card module fittings allowing simple installation into the Custom Pro Matrix hub.

I/O Interfaces

See the product

Amphenol

Amphenol – RJD2103-0050

Amphe-Dante are Dante® audio to analogue audio adapters, with one RJ45 Dante output, and one AX series XLR analogue input in a molded housing. Amphe-Dante are Dante® audio to analogue audio adapters, with one RJ45 Dante output, and one AX series XLR analogue input in a molded housing. Amphe-Dante products enable simple connection of analogue equipment to a Dante network and can receive audio channels from a Dante network and provide studio-quality, low-latency audio via an XLR connector to analogue audio equipment. Any audio available on the Dante network can be routed via the XLR outputs to an amplifier, powered speaker, mixing console, digital signal processor (DSP), or other analogue audio device.

I/O Interfaces

See the product

Mansion

Mansion – DIC2223A

DIC2223A is a high quality Dante interface box for converting two Dante channels to Analogue Audio outputs, and two Analogue Audio inputs to Dante network. Features: *Two Mic/Line XLR Inputs and Output on Front Panel *Terminal Block for Two Audio Outputs on Rear Panel *Converts Mic or Line Audio Signals to Dante Network *Mic or Line is Selectable for XLR Input *Switchable 48V Phantom Power for Mic XLR Input *Adjustable Mic/LIne Gain from -20 dB to +20dB for Each Input Channel *Two Audio Signal Outputs from Dante Network *Balanced or Unbalanced Signal Outputs *High Resolution 24 Bit for DAC and ADC *Power over Ethernet (PoE) or 24VDC power supply *Provides High Quality of Preamplifier for Microphones *Dimension: 116mm x 114.5mm x 53.1mm (WHD)

I/O Interfaces

See the product

DiGiCo – A168D Stage

Product Information

Specifications

Similar Products

Blustream – PRO-IN4HDA

Amphenol – RJD2103-0050

Mansion – DIC2223A

Stay connected to Dante

Support

Company

Dante Networking Alliance