Cart
← Back to Product Catalog

BARE – TNT-1608D

I/O Interfaces

More details

Similar Products

symetrix-xIn-12_1200px
  • Symetrix

Symetrix – xIn 12

The cost effective xIn 12 increases a system’s analog input channel capacity resulting in a reduction in overall price per channel. Designed exclusively for use with Edge and Radius DSP units, each of the twelve analog inputs’ parameters (5 gain levels, trim, mute, phantom power), along with bus assignments, are configured using SymNet Composer open architecture software. xIn 12 set up is logical and fast with no requirement to use third party software; there are no mechanical switches or circuit board jumpers to set.
    I/O Interfaces
  • Dante Ch: 0x64
  • 24-bit
See the product
s-track_logo
  • S-Track

S-Track – Ostrich D88

Ostrich series of products is an audio interface device based on Dante international general protocol. It can realize analog audio signal input, convert to digital audio signal output, route to any Dante audio transmission network device by Dante protocol, and realize high quality, long distance and low delay signal transmission. It supports the access of any Dante network digital audio, which can be converted into analog audio signal output, and can be connected to traditional analog audio devices such as mixer, power amplifier, processor and so on. The device uses high quality AD/DA signal conversion chip, provides 48 V of phantom power supply, and can access higher quality capacitive microphone.

    I/O Interfaces
See the product
neutrik-DANTE_Adapter-NA2-IO-DLINE|neutrik-DANTE_Adapter-NA2-IO-DLINE
  • Neutrik

Neutrik – NA2-IO-DLINE

This ruggedized handy box lets you connect your legacy audio gear to the Dante™ world. It works both as a ramp-on device to convert an analog LINE signal into a Dante™ signal and as a ramp-off box to come out of the Dante™ network with an anlog signal. Both can happen siumultaneously! The NA2-IO-DLINE is an end-of-network device. It is a breakout box which allows two channels of audio to be integrated into a Dante™ network. Simultaneously, NA2-IO-DLINE converts a Dante™ stream into analog audio signals. Hence, it is possible to use this tiny box to feed analog audio signals into the Dante™ network while at the same time receiving a mix from another Dante™ source. NA2-IO-DLINE is designed for harsh stage conditions. It therefore features lockable chassis connectors for both the audio and network connections. For fixed installations, the rubber protection can be removed. With optional mounting brackets or a rack panel, the box can be mounted below tables, in floor boxes, or in equipment racks.
    I/O Interfaces
  • Dante Ch: 2x2
  • 16-bit, 24-bit, 32-bit
See the product