Enable monitoring from up to a 64ch Dante™ Input in iAM Series products.
Installing a Wohler unit with the Dante hardware option into an existing and functioning Dante network is virtually plug and play. The iAM Series rear panel AoIP jack supports 1Gb/s and 100Mb/s Ethernet devices in Dante Audio over IP network configurations. Channel source selections are made by choosing Input Type ‘AoIP’ in the Configuration-Configure Presets page regardless of which AoIP option is installed. The iAM-series unit is set up at the Wohler factory to be used as a slave rather than a master within the Dante network. Other devices or software, such as a Dante Controller, are expected to be responsible for most device configurations and all audio routing.
▲ 4 audio (digital signal) inputs, 2 audio (digital signal) outputs, external GPIO
▲ ARM processor cooperates with embedded operating system to expand Cirrus Logic Audio Codec
▲ 24-bit, Σ- △ AD / DA, 44.1kHz, 48kHz, 88.2kHz, 96kHz sampling rates are optional,
▲ I2S digital audio format
▲ Freely set the sampling rate and equipment name
▲ Network audio transmission and control use standard Category 5 network cable (CAT5)
▲ Supports PCM16, PCM24, and PCM32 encodings, and can also use custom encoding formats
