RDL RN2ML

Product Information

The D-RN2ML is a complete wall-mounted Dante or AES67 audio network interface. It features one XLR mic or line input on the front panel, one stereo Mini-jack line-level input summed to mono on the front panel and two balanced line outputs on a rear-panel detachable wiring block. The module is configured and adjusted using RDL CONSOLE or other network control software. The D-RN2ML fits a standard US single-gang electrical box or can be used with the RDL EP-1 adaptor for mounting in EU/UK square back boxes with 60 mm distance screw hole mounting centers. The D-RN2ML is PoE powered and is available in multiple finishes with optional customized graphics.

Specifications

Dante Ch: 2x2
Bit Depth: 24-bit
Sample Rate: 44.1kHz, 48kHz, 88.2kHz, 96kHz
AES67 Enabled

Wohler – OPT-DANTE (iAM)

Enable monitoring from up to a 64ch Dante™ Input in iAM Series products.

Installing a Wohler unit with the Dante hardware option into an existing and functioning Dante network is virtually plug and play. The iAM Series rear panel AoIP jack supports 1Gb/s and 100Mb/s Ethernet devices in Dante Audio over IP network configurations. Channel source selections are made by choosing Input Type ‘AoIP’ in the Configuration-Configure Presets page regardless of which AoIP option is installed. The iAM-series unit is set up at the Wohler factory to be used as a slave rather than a master within the Dante network. Other devices or software, such as a Dante Controller, are expected to be responsible for most device configurations and all audio routing.

Dante Interface Cards

Dante Ch: 64x0
AES67 Enabled

See the product

Yamaha

Yamaha – HY144-D

The HY144-D is a digital I/O card for HY card slots, and is compatible with the Dante digital audio network over Gigabit Ethernet connections.

Dante Interface Cards

Dante Ch: 144x144
24-bit, 32-bit

See the product

Wohler

Wohler – OPT-DANTE (12G)

Installing a Wohler unit with the Dante hardware option into an existing and functioning Dante network is virtually plug and play. The rear panel AoIP jack supports 1Gb/s and 100Mb/s Ethernet devices in Dante Audio over IP network configurations. Channel source selections are made by choosing Input Type ‘AoIP’ in the Configuration-Configure Presets page regardless of which AoIP option is installed. The iAM-series unit is set up at the Wohler factory to be used as a slave rather than a master within the Dante network. Other devices or software, such as a Dante Controller, are expected to be responsible for most device configurations and all audio routing.

Dante Interface Cards

Dante Ch: 64x0
AES67 Enabled

See the product

RDL RN2ML

Product Information

Specifications

Similar Products

Wohler – OPT-DANTE (iAM)

Yamaha – HY144-D

Wohler – OPT-DANTE (12G)

Stay connected to Dante

Support

Company

Dante Networking Alliance