AES67 & DDM ready!
4×0 LINE IN (Bluetooth Stereo), LINE IN (XLR female) PoE / 5VDC Input Stereo L+R DANTE® Broadway Sample Rate: max. 192kHz | Latency: min. 0.25ms Network Speed: 1Gb/s / 100Mb/s Dimensionen: Gr. I+I (1×2/2×1) – 148x88x_mm Einbaumasse: 118x67x_mm (Ausschnitt x Tiefe) Farbe: Weiss (Feller 61), ähnlich RAL 9010 (auch als Standard u.a. Schwarz 60 oder Option RAL/NCS Farbton erhältlich!)
Ostrich series of products is an audio interface device based on Dante international general protocol. It can realize analog audio signal input, convert to digital audio signal output, route to any Dante audio transmission network device by Dante protocol, and realize high quality, long distance and low delay signal transmission. It supports the access of any Dante network digital audio, which can be converted into analog audio signal output, and can be connected to traditional analog audio devices such as mixer, power amplifier, processor and so on. The device uses high quality AD/DA signal conversion chip, provides 48 V of phantom power supply, and can access higher quality capacitive microphone.
The DD-RN40 is a complete wall-mounted Dante audio network interface. It features four XLR mic or line inputs on the front panels and two line outputs on a rear-panel detachable terminal block. The module is configured and adjusted using RDL CONSOLE or other network control software. The DD-RN40 fits a standard US dual-gang electrical box or an RDL WB-2 back box for installations in thinner European or equivalent walls. The DD-RN40 is PoE powered, and is available in multiple finishes with optional customized graphics.
Mic/Line to network section
The four XLR inputs are each converted to a separate Dante network transmit channel. Three gain settings are software-selectable for both the mic and line input ranges to match condenser or dynamic mic levels and standard line levels. P48 phantom voltage may be software enabled when an input is set for mic level.
Network to line section
Two Dante audio channels are converted to balanced line level. Each output provides +4 dBu balanced for a network digital audio level of -18 dBFS. Each output is equipped with a software controlled attenuator adjustable in 1 dB steps to a maximum attenuation of 62 dB then OFF. The outputs are connected through a detachable terminal block.
The outputs are intended for connection to RDL AMS connectors mounted in Decora®-style plates that match the DD-RN40. AMS audio connectors include RCA, Mini and XLR jacks. The output plate may be located together with the DD-RN40 in a triple gang box or may be mounted remotely in a single box.
Valid PoE power and synchronization to the Dante network are indicated by green LEDs visible from the front of the unit.
The DD-RN40 is a professional grade product with RDL mic preamplifiers for studio quality fidelity and low noise performance, coupled through XLR jacks housed in a steel chassis with dual powder-coated or stainless steel Decora front plates.
The DD-RN40’s superior performance specifications make it ideally suited to installations requiring network control and exceptional value in commercial networked audio systems. This full-featured product is engineered and manufactured in the U.S.A for continuous duty in demanding installations. Designed to outperform. Built to last.
