Lectrosonics - DNTWP

Lectrosonics – DNTWP

Product Information

The DNTWP Dante™ Audio Interface is a cost effective multi IO wall box. The unDX2IO features two balanced mic/line XLR inputs and two balanced XLR line outputs. All inputs and outputs can be used simultaneously and all audio channels are available separately. The unDX2IO is designed to fit into most dual gang US junction boxes and is PoE enabled, so all connectivity (power and data) is provided by a single CAT-5 cable. The unDX2IO’s size and IO density make it easy to put Dante connectivity wherever it’s needed near the audio source or sink thereby eliminating costly and interference prone analog wiring.

Specifications

Dante Ch: 2x2

BARE – AD-48

Features： 1. It has high efficiency and high sound energy output, excellent sound quality, perfect protection function and good electromagnetic compatibility characteristics. 2. Array full-frequency sound column with network transmission and pure digital power amplifier. (Equipped with special independent speaker control software), adjust the direction and angle of direct sound (pre-set 0°, ±15°, ±45°, ±60°, bypass) 3. With DSP network active sound column, you can remotely perform EQ, various filter switching, delay, compression, group mixing and other operations on 8 groups of units on the PC side 4. It has complete protection functions (short circuit protection, over current protection, over and under protection, DC protection, power limit, temperature limit, long-term output power limit, clipping limiter). 5. The sound column uses Dante digital audio interfaces (2) and 220V power supply to drive the power amplifier module. It also has a XLR interface with one input and one output, which can be multiple cascaded, and is equipped with two control network ports and a USB interface for The computer adjusts the 8 units of the sound column. 6. The back panel has a display screen and physical buttons, which can switch the sound column input mode, preset effect mode, etc., device TP display mode, lock screen and other operations

I/O Interfaces

See the product

BARE

BARE – BL-12SUB

Single 12-inch line array bass (for use with L-205)

I/O Interfaces

See the product

S-Track

S-Track – Ostrich D1616

Ostrich series of products is an audio interface device based on Dante international general protocol. It can realize analog audio signal input, convert to digital audio signal output, route to any Dante audio transmission network device by Dante protocol, and realize high quality, long distance and low delay signal transmission. It supports the access of any Dante network digital audio, which can be converted into analog audio signal output, and can be connected to traditional analog audio devices such as mixer, power amplifier, processor and so on. The device uses high quality AD/DA signal conversion chip, provides 48 V of phantom power supply, and can access higher quality capacitive microphone.

I/O Interfaces

Dante Ch: 16x16
24-bit

See the product

Lectrosonics – DNTWP

Product Information

Specifications

Similar Products

BARE – AD-48

BARE – BL-12SUB

S-Track – Ostrich D1616

Stay connected to Dante

Support

Company

Dante Networking Alliance