KS Audio – TA 4D with F MOD


Similar Products

ED-22B_Front
  • Keiga

Keiga – ED-22

* ED-22, Maximum supports 11Wx2@8Ω or PBTL mode for 22W@4Ω

* Built in Audio DSP for Volume, PEQ, Filter and Input Gain controls

* Dante™ Receiver as the audio input

* 2 sets two pins Euro-block Speaker output

* Signal Noise Ratio: ~ 93 dB

* Crosstalk in stereo mode: ~ - 64 dB

* THD + N (full power): < 0.5%

* Measure size: 114 (W) x 93(D) x 38(H) mm and Weight: 250g.

    Amplifiers
i60D_mit_Steckverbinder_frei
  • Aimline

AIMLINE – i60D PoE+ amp

The AIMLINE i60 D PoE+ amplifier impresses with its minimal size and its inner values. It is a PoE+ amplifier with an internal Sharc 300 MHz DSP and a power of 2 x 30 W. The input signal is simply connected directly to the i60 D PoE with a network CAT cable via Dante / AES67. Alternatively, 2 analog audio channels can be connected. The powerful DSP board provides access to gain, delay, 10 Bd EQ with IIR filter and 24 internal presets. Power is supplied via PoE+. This means that installations with very long cable runs can be carried out easily and inexpensively. The control and monitoring takes place via an IP-based network with the support of the PAN C software. All active AIMLINE and KLANGWERT digital systems can thus be controlled using just one software. Made in Germany

    Amplifiers
iAC_360_Dante
  • AMC

AMC – iAC360

Single-channel Class-D amplifier with 360 W power output. Created for 100 V and low impedance high-quality background music systems. Containing Dante digital input card, Balanced Phoenix & Stereo RCA input and audio link output connectors. Amplifiers have an RS232 control port for integration amplifiers with third-party automation systems that allow using iAC amplifiers in large and complex audio systems that can be automated and controlled remotely. Due to the integrated signal processor, amplifier‘s volume level, tone control, mute, and standby status can be controlled with a rotary selector as well as by RS232 protocol.

    Amplifiers