DMIX – GLA312a


More details

Similar Products

  • EAJAX

EAJAX – QC-106D/P

With the Eajax QC-106D/P and Dante technology, digital audio transmission and power can be simultaneously realized through one cat.5e network cable, without the need for additional power amplification equipment. With the Eajax QC-106D/P and Dante technology, digital audio transmission and power can be simultaneously realized through one cat.5e network cable, without the need for additional power amplification equipment.
    Speakers
Amadeus_PMX_15D_1000px|Amadeus_PMX_15D_1000px
  • Amadeus

Amadeus – PMX 15 D

The PMX 15 D system hosts a coaxial driver with a 15-inch (38 cm) neodymium woofer (LF) and a 2-inch diaphragm compression driver (HF). The PMX 15 D is bi-amplified using two dedicated high resonance digital amplifiers, featuring outstanding efficiency, with each amp delivering 1500 Watts (LF) and 400 Watts (HF) under 8 ohms. The PMX 15 D system hosts a coaxial driver with a 15-inch (38 cm) neodymium woofer (LF) and a 2-inch diaphragm compression driver (HF). The PMX 15 D is bi-amplified using two dedicated high resonance digital amplifiers, featuring outstanding efficiency, with each amp delivering 1500 Watts (LF) and 400 Watts (HF) under 8 ohms.  Each speaker channel is under control by a powerful, 64-bit digital processing unit capable of a 118 dB dynamic range. Each of these on-board DSP units include a module dedicated to managing core system parameters including system EQ, time alignment between sections, limiting, and transducer thermal protection. This level of control makes the PMX D Series fully protected and able to operate at the full extent of its abilities.
    Speakers
CX110P
  • DMIX

DMIX – CX110P

Speaker model: CX110P

Speaker type: 10”Active coaxial loudspeaker

Unit configuration: LF: 10" unit 2"(50mm)Voice coil

HF: 1.7"(44mm)Voice coil driver

Frequency response: 75Hz-17kHz(-10dB)

Rated power: LF: 160W, HF: 40W

Sensitivity: LF: 95dB, HF: 105dB

Sound pressure level: 124dB (peak)

Radiation Angle: 90°×90°

Crossover point: DSP control

Size (mm) : 480×332×340 (W×H×D)

Module amplifier power: HF:100W,LF:500W (Class D)

Module input link: 1 balanced XLR input / 1 set of Dante signal input and output / 1 set of LINK output

Module DSP control: RS485、USB 或 Dante

    Speakers