Digigram - Audioway Bridge B3

Digigram – Audioway Bridge B3

Product Information

The BRIDGE B3 is an intelligent gateway between AES/EBU digital audio and AES67/Dante™ synchronous audio-over-IP streams. In your infrastructure, the BRIDGE B3 is the ideal solution to connect any digital audio equipment with your Audio-over-IP studio. Thanks to its redundancy, the BRIDGE B3 can also provide secure distribution of your critical AES/EBU streams on any Dante redundant network.

Stainless steel 1U chassis power consumption <50 W
Front panel control interface for rapid overview of current status
Dual AC/DC power supply 4 configurable GPIOs Wordclock synchronisation 24-bit audio routing: 44.1 kHz to 96 kHz
AES67/Dante interface: 64-in/64-out EtherCON connector AoIP stream redundancy Integrated 4-port switch
AES/EBU interface: 16-in/16-out mono Wordclock synchronisation and SRC (sample rate conversion) on each input

Symetrix – xIn 4

The cost effective xIn 4 increases a system’s analog input channel capacity resulting in a reduction in overall price per channel. The cost effective xIn 4 increases a system’s analog input channel capacity resulting in a reduction in overall price per channel. Designed exclusively for use with Dante-enabled Symetrix DSP units, each of the four analog inputs’ parameters (5 gain levels, phantom power), along with bus assignments, are configured using Symetrix Composer open architecture software. xIn 4 set up is logical and fast with no requirement to use third party software; there are no mechanical switches or circuit board jumpers to set. Systems are simpler, cost less, and have fewer potential points of failure. A half-rack form factor conserves rack space, or, if preferred, the xIn 4 may be surface mounted. Features

Audio input (A/D) expander for systems that capitalizes on the surplus DSP of a Dante-enabled Symetrix DSP unit to bring overall system
costs down.
4 mic/line inputs, including +48 VDC phantom power, with the industry leading performance specifications of Edge and Radius.
Configured with Symetrix Composer. No third party software, archaic DIP switches, or complicated front panel menus.
Network audio expansion using Dante protocol over standard IT networks. Ultra low latency.
Rack mount and surface mount kits sold separately.

I/O Interfaces

Dante Ch: 4x4
24-bit

See the product

Cypress

Cypress – AIP-D4101

4 Balanced In, Analog Audio to Dante & 4 Balanced Out, Dante to Analog Audio

Adjustable phantom power from +0V to +48V.
Easily route audio with 3rd party units in the Dante network.
May be powered directly by PoE when connected to a Gigabit Ethernet switch that provides PoE (802.3af)

I/O Interfaces

See the product

Sound Devices

Sound Devices – A10-RACK

The A10-RACK offers convenient mounting, powering, RF, and audio connectivity for four uni- or SuperSlot wireless receivers in its 1 RU chassis. It is designed for dual-channel receivers from Audio Limited, including the A10-RX, plus slot receivers from Lectrosonics and Wisycom. The A10-RACK includes built-in antenna distribution with powering for active antennas. Up to eight channels of audio from single or dual-channel receivers appear on both its XLR outputs and over Dante™ audio-over-Ethernet.

I/O Interfaces

See the product

Digigram – Audioway Bridge B3

Product Information

Similar Products

Symetrix – xIn 4

Cypress – AIP-D4101

Sound Devices – A10-RACK

Stay connected to Dante

Support

Company

Dante Networking Alliance