Product Information
It features built-in power amplifiers and digital signal processing modules, 360-degree rotatable tweeter and pursuit of high-quality sound quality.
It features built-in power amplifiers and digital signal processing modules, 360-degree rotatable tweeter and pursuit of high-quality sound quality.
Dante PoE Speaker can realize its multifunction of the POE power supply, audio transmission and signal control via a RJ45 Ethernet port. It can obtain power supply from any Ethernet switch of 802.3 or above standard. Over Dante™ Ethernet that transmits 24-bit audio (44.1K/48KHz) and its control signal can be routed through the Dante™ Controller. All these functions can perform remotely on the PC or Mac by Dante Controller Software.
Technical parameters:
Speaker model: CA-402D
Unit configuration: 2×4"(100mm) Full frequency unit
Frequency range: 110Hz-20kHz
Rated power: 60W
Sound pressure level: 113dB
Sensitivity: 93dB
Coverage Angle: 100°×60°
DSP processing: 1 DSP, with gain, equalization, voltage limit, noise gate, mute control adjustment
Connection mode: RJ45 interface
Size (mm) : 145×344×180 (W×H×D)
The speaker uses a patented design of a 4-inch bass + 3 0.5-inch tweeter coaxial unit. In terms of sound quality, it not only has the characteristics of high phase fidelity of the full-range speaker, but also realizes the output of a more natural sound in the form of a standard point source. At the same time, it also has the powerful expressive power of the crossover speakers in the high and low frequencies, making its sound level more distinct and the sense of detail more prominent. Three tweeters are arranged in a vertical line to form a linear array pattern, which makes the high-frequency horizontal pointing wider and can take care of more areas. The coaxial unit design can reduce the volume of the speaker as much as possible, and the appearance is more compact and elegant.
The speakers use Dante digital audio interface and POE network power supply to drive the power amplifier module. Only one network cable is needed to supply audio signals and power at the same time. In a digital audio system, our product is a terminal node that provides the terminal playback function of a digital audio system.