Cart
← Back to Product Catalog

Montarbo – WIND PRO 210A

Speakers

More details

Similar Products

CorelSDK_0004
  • Lucky Tone

Lucky Tone – DANTE 640DUO POE DSP

Dante PoE Speaker can realize its multifunction of the POE power supply, audio transmission and signal control via a RJ45 Ethernet port. It can obtain power supply from any Ethernet switch of 802.3 or above standard. Over Dante™ Ethernet that transmits 24-bit audio (44.1K/48KHz) and its control signal can be routed through the Dante™ Controller. All these functions can perform remotely on the PC or Mac by Dante Controller Software.

    Speakers
See the product
hs-28_400px
  • VUE Audiotechnik

VUE Audiotechnik – hs-28

Achieving a better balance of output and musicality starts by focusing on those frequencies that matter most — the critical “sweet spot” between 35 and 80 Hz. After all, a properly designed full-range speaker should be more than capable of operating effectively down to 80 Hz. Most manufacturers design subwoofers that move as much air as possible in order to achieve maximum output. At VUE Audiotechnik, our designers believe that a high-performance subwoofer shouldn’t sacrifice definition in favor of SPL alone. Achieving a better balance of output and musicality starts by focusing on those frequencies that matter most — the critical “sweet spot” between 35 and 80 Hz. After all, a properly designed full-range speaker should be more than capable of operating effectively down to 80 Hz. In the hm-28, dual spider long-excursion woofers feature large, 4-inch voice coils for increased power handling and reduced power compression. Each 18” woofer has a dedicated amplifier and power supply good for total of 4,000 W of power.  Active onboard electronics include system-optimized amplification and DSP for each driver and cabinet combination. 
    Speakers
See the product
s215
  • Cadac

Cadac – S215

The S215 is a self-powered high-end subwoofer, which features 2 x 15" ported woofers. The power output of 4000 W (RMS) ensures for © very high SPL down to a frequency of 40 Hz. It can be combined with all products of the CADAC range and be used as subwoofer extension in ground stack configuration for point sources or line arrays and can be also used as ground stack horizontal subwoofer array. The DSP-electronic has 2 power amplifiers and 2 DSP channels. Internally, one S215 has 2 amplifier and 2 DSP channels. The CADAC DSP-core module platform is integrated with the amplifier section into the loudspeaker. Cabinets are electrically connected by the CADAC C-Link audio and command interface. The CCP control and prediction software can connect to the array via LAN for command and control, Auto-EQ and to calculate sound prediction on listener areas. With the CMAP (mapping optimization mode), the dispersion can be adjusted and optimized according to the listener area for the application of subwoofer arrays. CMAP enables to create arbitrary radiation patterns for the listener area with ground stack horizontal arrays.

    Speakers
See the product