Cart
← Back to Product Catalog

CS702D

Amplifiers

More details

Similar Products

Blaze by Sonance - PowerZone Connect 3004d
  • Blaze by Sonance

PowerZone™ Connect 3004D

The PowerZone™ Connect 2U series is a line of ultra-reliable, full-matrix DSP-enabled Class-D amplifiers that delivers exceptional system configuration and flexible output, with a total system power ranging from 1000 W to 6000 W.
    Amplifiers
See the product
i60D_mit_Steckverbinder_frei
  • Aimline

AIMLINE – i60D PoE+ amp

The AIMLINE i60 D PoE+ amplifier impresses with its minimal size and its inner values. It is a PoE+ amplifier with an internal Sharc 300 MHz DSP and a power of 2 x 30 W. The input signal is simply connected directly to the i60 D PoE with a network CAT cable via Dante / AES67. Alternatively, 2 analog audio channels can be connected. The powerful DSP board provides access to gain, delay, 10 Bd EQ with IIR filter and 24 internal presets. Power is supplied via PoE+. This means that installations with very long cable runs can be carried out easily and inexpensively. The control and monitoring takes place via an IP-based network with the support of the PAN C software. All active AIMLINE and KLANGWERT digital systems can thus be controlled using just one software. Made in Germany

    Amplifiers
See the product
ashly-nXe-4004_600px
  • Ashly Audio

Ashly – nXe4004bd

The nXe4004bd unit is a 4 channel multi-mode amplifier capable of driving 2 Ohm loads at full power. The maximum rated output power is 400W per channel at Low Z, 70V, and 100V mode. There is an automatic but defeatable sleep mode consuming <1W, and instant standby mode controlled by contact closure or software. A switch mode power supply auto-detects 120VAC or 240VAC mains, and a Neutrik® powerCON is used for the AC cord. Each channel has selectable output mode of Low Z, 70V, or 100V, an 80Hz high-pass filter, input limiter, and input gain settings of 26dB, 32dB, 38dB, or 1.4V. Each channel has remote DC level control. Input connectors is Neutrik® XLR/TRS combo jack and Euroblock, while output connectors is Neutrik® speakON. The unit has a front panel power switch and level controls that can be disabled. LEDs indicate Protect, Sleep, Disabled, Com, and Bridge mode status, as well as Temperature, Output Current, Output Signal, and Clipping/Mute status per channel. The unit has Ethernet control with a real-time clock for event scheduling. The unit has serial data remote control, aux preamp outputs, preset control, fault condition logic outputs, optional network audio and AES3 digital audio capability. The amplifier has temperature dependent variable speed forced-air cooling.
    Amplifiers
  • Dante Ch: 4x0
  • 44.1kHz-96kHz
See the product