ARX - NetSPLIT

ARX – NetSPLIT

Product Information

The ARX NetSplit is a unique ‘Dante / Analog Splitter that is switchable into Dante mode or Analog mode.

The ARX NetSplit is a unique ‘Dante / Analog Splitter that is switchable into either of two modes:

In Dante mode it will extract 2 channels of digital audio from the network via aRJ45 Ethernet input, and split them to 2 channels of 1:4 splitter
In Analog mode it can take 2 channels of Analog audio, and split them to 2 channels of 1:4 splitter

The NetSplit can receive audio channels from a Dante network and provide studio quality, low latency audio via balanced XLR output connectors to analog audio equipment.

Thus any audio available on the network can be routed via the NetSplit to an amplifier, powered speaker(s), mixing console, digital signal processor and many other analog audio devices.

Equipson – DD4

DD4 devices are gateways used to convert DANTE (Digital Audio Network Through Ethernet - developed by AUDINATE) protocol. These devices allow the extraction of analog audio signals from the DANTETM network as well as the introduction of analog channels within the same network.

DD4 is a device designed for use in installation, for which the analog inputs and outputs are made through Euroblock 3.5mm connectors.

It has balanced inputs and outputs to provide greater immunity to noise that interferes with audio signal lines.

I/O Interfaces

See the product

alcorn-mcbride_VP16PCB_circuit_board_600px|alcorn-mcbride_VP16PCB_circuit_board_600px

Alcorn McBride

Alcorn McBride – V-Page VP16PCB

VPage provides facility-wide intelligent paging using Dante audio networks. The configuration of your paging network, such as Q-Sys, is completely programmable using the software in the DSP system. This includes zone assignments, button and light behaviors and zone priorities. Each VPage station includes user-programmable illuminated buttons, microphone input, and level control. An expansion connector allows for an additional 16 illuminated pushbuttons. A single Ethernet cable carries audio, power, and control between the VPage station and the equipment rack. A facility may incorporate an unlimited number of VPage stations by simply connecting them to PoE enabled network switches. The VP16PCB is the circuit board only, for mounting in custom PA stations.

I/O Interfaces

See the product

Arista

Arista – ARS-0202-A11

E-Vocal DUO+ is a dual channel analog input and dual channels analog output Dante converter.

The product consists of four models:

E-Vocal ARS-0202-A00
E-Vocal ARS-0202-B00
E-Vocal ARS-0202-A11
E-Vocal ARS-0202-B11

E-Vocal ARS-0202-A11 connects your legacy audio gear to the Dante ® world. It allows two channels of audio analog inputs to be integrated into a Dante ® network and converts a Dante ® stream into two channels of analog audio output signals. It has two XLR microphone inputs with an adjustable gain control preamplifier for studio quality fidelity and low noise performance dynamic or condenser microphones. Two audio signal outputs allow Lip-Sync delay of up to 170 ms/ch (fs = 48 kHz) to synchronize the audio stream to the video stream. It has a built-in web-based controller for microphone gain control and Lip-Sync delay control. It has an RJ45 copper network interface and can be powered by PoE or 12VDC. Dante DUO+ has a rubber protection shell and rack mount brackets as optional items. More info: https://www.aristaproav.com/product/duo-plus/

I/O Interfaces

See the product

ARX – NetSPLIT

Product Information

Similar Products

Equipson – DD4

Alcorn McBride – V-Page VP16PCB

Arista – ARS-0202-A11

Stay connected to Dante

Support

Company

Dante Networking Alliance