AEQ – CAPITOL IP Board


Similar Products

WING-DANTE_P0EGD_Front_XL
  • Behringer

Behringer – WING-DANTE

The 64-channel 48 kHz bi-directional audio interface brings even more I/O options to the WING by making it ready for integration with Dante enabled IP networks. Dante is a proprietary AoIP solution from Audinate, which also complies with the AES67 standard for improved interoperability. It uses either standard 100Mbit/s or Gigabit Network infrastructure with DSCP-based QoS, with support for mixed sample and bit rates coexisting on the same network. The WING-DANTE card utilizes 24-bit signal transmission with sample-accurate synchronization and low latency, ensuring the highest audio integrity. Its secondary input allows you to set up a seamless, redundant network access.

    Dante Interface Cards
  • Dante Ch: 64x64
  • 24-bit
MNS-AMPMC230POE
  • MONISMS

MONISMS – MNS-AMPMC230POE

The POE DANTE/AES67 Audio Amplifier module MNS-AMPMC230POE, Built-in to your 4-8 ohm speaker, that instantly Dante-enables your speakers. The POE DANTE/AES67 Audio Amplifier module MNS-AMPMC230POE, Built-in to your 4-8 ohm speaker, that instantly Dante-enables your speakers. The MONISMS Dante Audio Amplifier is a compact power amplifier module that drives small 4-8Ω speakers. The MONISMS Dante Amplifier has two outputs, each with 15W of power into an 4-8Ω load, This makes the module ideal for powering small areas consisting of only a few low power speakers. The module's audio input is via an Ethernet audio network, allowing the use of the DANTE/ AES67 audio network protocol. MNS-AMP230POE is powered by standard POE+ and has a MAX power of 30 watts [2*15W]. If there is not  POE+  used,  It can used the external 24VDC power supply.
    Dante Interface Cards
MDT44-E2
  • Kingray

Kingray – MDT44_E2

  • 4 audio (digital signal) inputs, 2 audio (digital signal) outputs, external GPIO
  • 24-bit, Σ- △ AD / DA, 44.1kHz, 48kHz, 88.2kHz, 96kHz sampling rates are optional,
  • I2S digital audio format
  • Freely set the sampling rate and equipment name
  • Network audio transmission and control use standard Category 5 network cable (CAT5) by 2*RJ45
  • Supports PCM16, PCM24, and PCM32 encodings, and can also use custom encoding formats
    Dante Interface Cards