Product Information
The Topp Pro RTDLM808 is an 8×8 digital matrix with gating, compression, expansion, delay, and crossover capabilities.
Specifications
- Dante Ch: 8x8
- Bit Depth: 24-bit
- Sample Rate: 48kHz
Topp Pro – RTDLM808
Similar Products
- Arista
Arista – ARS-0002-A01
E-Vocal DUO is a dual channel analog input or dual channel analog output Dante converter. It consists of three models:
- E-Vocal ARS-0002-A00
- E-Vocal ARS-0002-A01
- E-Vocal ARS-0200-A00
E-Vocal ARS-0002-A01 converts a Dante ® stream into two channels of analog audio output signals. The two audio signal outputs of ARS-0002-A01 allows Lip-Sync delay of up to 170 ms/ch (fs = 48 kHz) to synchronize the audio stream to the video stream. The delay control switch on the E-Vocal ARS-0002-A01 can add delay in the range of 0~170ms by 32 increments. It can be powered by PoE or 5VDC via Micro USB connector. More info: https://www.aristaproav.com/product/duo/
- I/O Interfaces
- BARE
BARE – DP-8
Features：
1. The frameless design of the mesh cover makes it fit the wall and ceiling
better;
2. The network cable realizes signal transmission and power supply;
3. Automatically assign IP address through router DHCP;
4. Each receiving channel can be controlled independently, and can be
applied to any location in the local area network
5. It has high efficiency and high sound energy output, excellent sound
quality, perfect protection function and good electromagnetic compatibility
characteristics.
6. The built-in DSP network active speaker can remotely control the EQ and
pressure limit of the active speaker on the PC side.
7. It has perfect protection functions (short circuit protection, over
current protection, over and under protection, DC protection, power limit,
temperature limit, long-term output power limit, clipping limiter).
8. The speaker uses Dante digital audio interface and PoE network power
supply to drive the power amplifier module, and only one network cable is
needed to realize the simultaneous supply of audio signal and power.
- I/O Interfaces
- Dante Ch: 1x0
- 24-bit
- AMX
AMX – DGX6400-ENC
The new Enova DGX 6400 Enclosure (DGX6400-ENC) is a Digital Media Switcher that is ready to support 4K and Ultra High Definition (UHD) content.
The new Enova DGX 6400 Enclosure (DGX6400-ENC) is a Digital Media Switcher that is ready to support 4K and Ultra High Definition (UHD) content. This robust solution includes a NetLinx® NX Integrated Controller, redundant power supplies and can be populated with Enova DGX video input and output boards in addition to optional audio -switching boards. There are four connections per video board, and each enclosure holds sixteen video input boards and sixteen video output boards for a maximum matrix of 64x64.
The Enova DGX 6400 adds several new capabilities such as automatic setup of DXLink endpoints, single IP addressing for multiple endpoints, and a new web interface to greatly simplify installation and configuration. The new advanced Audio Switching Boards add audio breakaway capabilities and parametric EQ on each DGX output.
The Enova DGX 6400 is far beyond a modular media switcher with built-in controller – it functions as the centerpiece of a complete integrated solution that manages and distributes analog and digital audio and video including HDMI/HDCP, control and Ethernet. Easily integrate HDCP into system designs and enjoy hassle-free plug-and-play operation. No tools, no delays and no key constraints – it just works with AMX's exclusive InstaGate Pro® Technology. Built for today's and tomorrow's needs, a comprehensive set of Enova DGX boards can be used in conjunction with DXLink and DGX Transmitters and Receivers to provide an end-to-end distribution system over twisted pair cable or fiber. An integrated NetLinx NX Controller and embedded Ethernet switch enables management of the entire solution including source equipment and display devices located throughout the environment – all from a single point of control.
In addition to eliminating HDCP delays, InstaGate Pro allows traditionally key limited sources to be switched freely to all connected HDCP compliant displays – eliminating HDCP key limitations that plague large applications. Built-in SmartScale® Technology on every output provides video that is perfectly scaled for each connected display, eliminating the integration challenges that can occur when sources and displays have different supported resolutions – making it easy to specify, easy to install and easy to use. With the powerful combination of analog-to-digital signal conversion, video scaling and high speed digital switching the system delivers perfect video every time – regardless of signal type.
As part of a complete distribution system, easily send analog or digital audio and video including HDMI with HDCP signals, plus control 10 Km over single mode fiber or 300 meters over multimode fiber; send all this plus power up to 100 meters over standard twisted pair cable to and from the Enova DGX using the DXLink Twisted Pair and Fiber Transmitters/Receivers.
- I/O Interfaces
- Dante Ch: 32x32