Cart
← Back to Product Catalog

Studio Technologies – Model 372A Intercom Beltpack

Intercoms

More details

Similar Products

glensound-MPI005HDMKII
  • Glensound

Glensound – GS-MPI005HD MKII

Glensound invented the Broadcaster’s mobile phone and our GS-MPI005 and GS- MPI005HD mobile phone racks have been hugely popular with broadcasters and can be found in daily use in outside broadcast trucks and studios around the World. On the surface the new GS-MPI005HD MKII looks different to its predecessors as it has touch screen colour displays for each phone module fitted. A traditional telephone handset interface is also now provided to allow an operator to communicate off air before handing the call over to broadcast. The handset interface can also dial and answer calls. No new modern piece of audio broadcast equipment is complete without an AoIP solution so the new GS-MPI005HD MKII has a Dante® interface. Of course the crystal clear sound and audio inputs & outputs that are interference free of cell phone noise that made the original units so popular also feature in this new design.
    Intercoms
  • Dante Ch: 4x4
  • 24-bit
See the product
ctp-systems-FWD6006s|ctp-systems-FWD6006s
  • CTP Systems

CTP Systems – FWD6006

The FWD6006 is a six channel desktop version of our FWD8000. It is a Dante enabled four wire box with six four wire inputs, six four wire outputs plus six IFB inputs. A mix output and a hot microphone output are also available on the network. In addition to the network connections three of the four wire inputs and outputs are mirrored onto the rear of the unit for local analogue use as well as two IFB inputs. Power may be supplied by PoE, an external 12 volt supply or battery or via the IEC mains inlet. The FWD6006 is a six channel desktop version of our FWD8000. It is a Dante enabled four wire box with six four wire inputs, six four wire outputs plus six IFB inputs. A mix output and a hot microphone output are also available on the network. In addition to the network connections three of the four wire inputs and outputs are mirrored onto the rear of the unit for local analogue use as well as two IFB inputs. Power may be supplied by PoE, an external 12 volt supply or battery or via the IEC mains inlet. Each channel has a cut switch, a ifb monitor button plus a vox incoming audio present indicator. Press the talk keys down for momentary operation and up to latch. The latch operation can be defeated if required. Units can be supplied with a headphone jack or a 5 pin XLR headset connector. There is also a microphone cut button. When a talk key is pressed incoming audio to the loudspeaker is normally dimmed to prevent feedback, the level may be adjusted or defeated as required. The FWD6006 has a secondary ethernet interface which may be used a switch output or for network redundancy. Mains requirement is 110-240VAC 50/60Hz. Dimensions: 100mm high, 180mm deep, 200mm wide.
    Intercoms
  • Dante Ch: 16x16
  • 48kHz-96kHz
See the product
oratis-talk-12-x-dante_600px|oratis-talk-12-x-dante_600px
  • DELEC

DELEC – oratis Talk 12 X Dante

The DELEC Talk 12 X Dante is a 12-key rackmount subscriber panel with individual rotary encoders equipped with a Dante interface so it can be connected directly to a Dante network without the need for an additional convertor. The DELEC Talk 12 X Dante is a 12-key rackmount subscriber panel with individual rotary encoders equipped with a Dante interface so it can be connected directly to a Dante network without the need for an additional convertor. These units can be hooked up to any DELEC intercom unit equipped with a Dante interface, e.g. CS 1624. These new subscriber panel models allow operators to target specific addresses or – using DELEC NAMs – announcement speakers. All three models come with Dante Primary and Secondary ports for fully redundant operation. In a different scenario, these two ports can be used to daisy-chain several subscriber panels, reducing cabling requirements dramatically. As a result, these new subscriber panels are not only perfect for broadcast and theatre environments but also for any application which requires long cable runs.
    Intercoms
See the product