Cart
← Back to Product Catalog

Studio Technologies – Model 5422A Dante Intercom Audio Engine

Intercoms

More details

Similar Products
  • Studio Technologies

M5365

the Model 5365 supports a number of command types outlined in the STcontroller protocol. Typically, the Device Specific commands are the ones users are looking to access and listed in this document.
    Intercoms
  • Dante Ch: 2x2
  • 24-bit
See the product
rts-adam-m_1200px|rts-adam-m_1200px
  • RTS

RTS – ADAM-M

The ADAM-M is a mid-size modular matrix intercom. The ADAM-M is a mid-size modular matrix intercom.
  • 8 GPIO's Standard per Frame
  • Compatible with most all Current & Legacy RTS Digital Matrix Intercom Keypanels & Accessories
  • Dual-Purpose Ports Support BOTH Keypanel and Four-Wire Audio
  • Supports Fully Redundant Power Supplies & Controllers
  • Individual Cross-Point Level Controls
  • Integrated Support for RTS Intelligent Trunking
  • Multi-Level IFB, ISO, Party Lines, Groups, and GPI's all STANDARD
  • Non-Volatile Configuration & Crosspoint Memory
  • RealTime Online Configuration & Monitoring
  • RTS UPL (User-Programmable Language) for Custom System Configurations via Pull-down Menus
  • Supports 16 to 880 users per system based on 3 RU frame(s)
  • Supports Custom Cards for Widely Used Industry Interface
  • Widest Variety of Interface Cards in the Industry
  • Widest Variety of Wiring Options in the Industry
    Intercoms
  • Dante Ch: 128x128
  • 24-bit
See the product
ctp-systems-FWD8000f
  • CTP Systems

CTP Systems – FWD8000

The FWD8000 is a Dante enabled four wire box with eight four wire inputs, eight four wire outputs plus eight IFB inputs. A mix output and a hot microphone output are also available on the network. In addition to the network connections four of the four wire inputs and outputs are mirrored onto the rear of the unit for local analogue use as well as two IFB inputs. Power may be supplied by PoE, an external 12 volt supply or battery or via the IEC mains inlet. The FWD8000 is a Dante enabled four wire box with eight four wire inputs, eight four wire outputs plus eight IFB inputs. A mix output and a hot microphone output are also available on the network. In addition to the network connections four of the four wire inputs and outputs are mirrored onto the rear of the unit for local analogue use as well as two IFB inputs. Power may be supplied by PoE, an external 12 volt supply or battery or via the IEC mains inlet. Each channel has a cut switch, a ifb monitor button plus a vox incoming audio present indicator. Press the talk keys down for momentary operation and up to latch. The latch operation can be defeated if required. Units can be supplied with a headphone jack or a 5 pin XLR headset connector.  There is an 'all talk' key which can be set to talk to any or all of the four wire outputs. There is also a microphone cut button. When a talk key is pressed incoming audio to the loudspeaker is normally dimmed to prevent feedback, the level may be adjusted or defeated as required.  The FWD8000 has a secondary ethernet interface which may be used a switch output or for network redundancy. Mains requirement is 110-240VAC 50/60Hz. Dimensions: 1RU 200mm deep.
    Intercoms
  • Dante Ch: 16x18
See the product