HPX-12000


More Details

Similar Products

2019120412013727
  • S-Track

S-Track – MAIA2600

Features:

· High-performance ADI DSP processor, high-fidelity and low-noise 24-bit A / D and D / A conversion;

· Built-in Dante network transmission module, support 4 Dante signals / 4 analog signal inputs, 4 sets of digital power amplification output;

· With limited amplitude, frequency division, delay, PEQ, mute, inversion, gain adjustment, level indication functions, etc .;

· Multiple sets of scene save, recall, import and export functions;

· USB / network control interface, it can realize PC control for parameter configuration, scene recall and save;

· 3.97-inch color TFT resistive touch screen, Chinese and English menu operation, more comprehensive and intuitive display content

· Switch protection against shock, overcurrent, overheating, temperature detection after overheating protection, short circuit, DC protection;

    Amplifiers
audac-AMP203
  • AUDAC

AUDAC – AMP203

The AMP203 is a revolutionary small amplifier, featuring network input through Dante providing a complete media networking solution to distribute uncompressed audio via standard Ethernet networks with near-zero latency, while allowing all other data to be connected on the same network. The AMP203 is a revolutionary small amplifier, featuring network input through Dante providing a complete media networking solution to distribute uncompressed audio via standard Ethernet networks with near-zero latency, while allowing all other data to be connected on the same network. It features various DSP functionalities, including Low-pass, Band-pass and High-pass filters. All configurations can be made via RS485 and Ethernet. The output connector has been implemented using a 4-pin terminal block connector, featuring an output power of 30W per channel and 60W when bridged. Using PoE (Power over Ethernet) the amplifier receives both power and signal through a single networking cable, this way flexibility is maximized while needed cabling is kept at a minimum. The compact convection cooled enclosure eliminates any humm or buzz otherwise caused by a fan. Various optional mounting brackets are available making it ideal for mounting under a desk, in a closet or on the wall, 19” rack mounting hardware is available as well.
    Amplifiers
  • Dante Ch: 4x0
  • 24-bit
  • Lake People

G103-D-4

Lake People Phone-Amp G103D4 is a headphone amplifier intended for DANTE networks. The G103D4 model comes with a DANTE 4/4 input and two independent stereo amplifiers. 24 Bit / 192 kHz D/A converters with a Signal-to-noise ratio >105 dB and THD+N as low as 0,002 % are driving the powerful headphone amplifiers. These are best suited to drive any headphones from low to high impedance and with low or high sensitivity. To adapt the amp to demanding headphones, to further reduce the noise level or to maximize the travel of the volume control, the gain is internally adaptable by Dip-Switches to optimize the amp; The DANTE digital audio signals are input via a standard RJ45 connector. Lake People G103D4 will accept 4 audio channels. The unpacked audio signals are input to two high quality D/A converters. The recovered analogue signals are buffered, attenuated in the analogue domain and then sent to powerful headphone amplifiers. If required, additional gain of +6 dB or +12 dB can be set by Dip-Switches inside the amp. Each amp section offers a 1/4” and 3.5 mm phone jack which may be used simultaneously. Power supply for the amp is accomplished either by PoE (Power-over-Ethernet) or by a USB wall plug adaptor (not supplied) with USB-B or USB-C connector. The case, front and back panel of G103D4 is made of rugged black anodized aluminum, the lettering is laser engraved. The volume knobs are also made of solid aluminum.
    Amplifiers
  • Dante Ch: 4x0
  • 24-bit