Cart
← Back to Product Catalog

Glensound – Beatrice W1

Intercoms

More details

Similar Products

npx_g1040_front
  • Biamp

Biamp – NPX G1040

The NPX G1040 is a 4-button convenience paging station with gooseneck microphone for use in Qt X and Tesira systems. The G1040 features embedded DSP and on-board memory to support standard and advanced public address functionalities. Digital audio and control data can be transmitted by either AVB or Dante®. The NPX G1040 can store four user-configurable page codes and up to 10 prerecorded messages. Additionally, the G1040 supports both tabletop and wall mounting with a removable “foot” that allows the paging station to be mounted flat against any surface, and a K-slot is included for enhanced physical security via an optional Kensington® lock. The NPX G1040 meets convenience paging requirements for facilities of all sizes.

    Intercoms
See the product
ctp-systems-FWD6006s|ctp-systems-FWD6006s
  • CTP Systems

CTP Systems – FWD6006

The FWD6006 is a six channel desktop version of our FWD8000. It is a Dante enabled four wire box with six four wire inputs, six four wire outputs plus six IFB inputs. A mix output and a hot microphone output are also available on the network. In addition to the network connections three of the four wire inputs and outputs are mirrored onto the rear of the unit for local analogue use as well as two IFB inputs. Power may be supplied by PoE, an external 12 volt supply or battery or via the IEC mains inlet. The FWD6006 is a six channel desktop version of our FWD8000. It is a Dante enabled four wire box with six four wire inputs, six four wire outputs plus six IFB inputs. A mix output and a hot microphone output are also available on the network. In addition to the network connections three of the four wire inputs and outputs are mirrored onto the rear of the unit for local analogue use as well as two IFB inputs. Power may be supplied by PoE, an external 12 volt supply or battery or via the IEC mains inlet. Each channel has a cut switch, a ifb monitor button plus a vox incoming audio present indicator. Press the talk keys down for momentary operation and up to latch. The latch operation can be defeated if required. Units can be supplied with a headphone jack or a 5 pin XLR headset connector. There is also a microphone cut button. When a talk key is pressed incoming audio to the loudspeaker is normally dimmed to prevent feedback, the level may be adjusted or defeated as required. The FWD6006 has a secondary ethernet interface which may be used a switch output or for network redundancy. Mains requirement is 110-240VAC 50/60Hz. Dimensions: 100mm high, 180mm deep, 200mm wide.
    Intercoms
See the product
delec-dante-desk16-crop|delec-dante-desk16-crop
  • DELEC

DELEC – Desk 16 Dante

The DELEC Desk 16 Dante is a 16-key desktop subscriber panel equipped with a Dante interface so it can be connected directly to a Dante network without the need for an additional convertor. These units can be hooked up to any DELEC intercom unit equipped with a Dante interface, e.g. CS 1624. These new subscriber panel models allow operators to target specific addresses or – using DELEC NAMs – announcement speakers. All three models come with Dante Primary and Secondary ports for fully redundant operation. In a different scenario, these two ports can be used to daisy-chain several subscriber panels, reducing cabling requirements dramatically. As a result, these new subscriber panels are not only perfect for broadcast and theatre environments but also for any application which requires long cable runs.
    Intercoms
See the product