Cart
← Back to Product Catalog

ED4-1500

Amplifiers

More Details

Similar Products

POE-DANTE-AES67-Audio-Amplifiers-MNS-AMP30XXA-1P-1280X720-001-768x432
  • MONISMS

MONISMS – MNS-AMP30XXA-1P

The MONISMS Dante Audio Amplifier is a compact power amplifier module that drives small 4-8Ω speakers [Ceiling Speaker, In-wall Speaker, Pendant Speaker Column Speaker etc.] The MONISMS Dante Amplifier Power 30W, 4-8Ω load, This makes the module ideal for powering small areas consisting of only a few low power speakers.


The module's audio input is via an Ethernet audio network, allowing the use of the DANTE/ AES67 audio network protocol.
MNS-AMP30XXA-1P is powered by standard POE+ and has a MAX power of 30 watts. If there is not  POE+  used,  It can used the external 19VDC power supply.
Dante Audio Amplifier  can be mounted on a DIN rail or screwed onto a panel or wall for easy installation in a remote closet near the speaker area.

[Model:MNS-AMP3011A-1P] 1 Channel, 30W Output, [1 Pair Speaker Terminals].
[Model:MNS-AMP3012A-1P] 1 Channel, 2*15W Output, [2 Pairs Speaker Terminals].
[Model:MNS-AMP3022A-1P] 2 Channels, 2*15W Output, [2 Pairs Speaker Terminals].

    Amplifiers
See the product
ashly-nXe-1.54_600px|ashly-nXe-1.54_600px
  • Ashly Audio

Ashly – nXe1.54bd

The nXe1.54bd is a 2 channel multi-mode amplifier capable of driving 2 Ohm loads at full power. The maximum rated output power is 1,500W per channel at Low Z and 70V modes, and 1,250W in 100V mode. There is an automatic but defeatable sleep mode consuming <1W, and instant standby mode controlled by contact closure or software. A switch mode power supply auto-detects 120VAC or 240VAC mains, and a Neutrik® powerCON is used for the AC cord. Each channel has selectable output mode of Low Z, 70V, or 100V, an 80Hz high-pass filter, input limiter, and input gain settings of 26dB, 32dB, 38dB, or 1.4V. Each channel has remote DC level control. Input connectors is Neutrik® XLR/TRS combo jack and Euroblock, while output connectors is Neutrik® speakON. The unit has a front panel power switch and level controls that can be disabled. LEDs indicate Protect, Sleep, Disabled, Com, and Bridge mode status, as well as Temperature, Output Current, Output Signal, and Clipping/Mute status per channel. The unit has Ethernet control with a real-time clock for event scheduling. The unit has serial data remote control, aux preamp outputs, preset control, fault condition logic outputs, optional network audio and AES3 digital audio capability. The amplifier has temperature dependent variable speed forced-air cooling.
    Amplifiers
See the product
NetPA 204 POE
  • Extron Electronics

Netpa 204 POE

  • Four Channel PoE Amplifier with Dante and DSP
  • Up to 20 watts rms output power per channel
  • Integrated DSP with 4x4 mix matrix
  • DDM and AES67 Support
  • PoE operation with scalable output power
    Amplifiers
See the product