Cart
← Back to Product Catalog

Cobalt C-50 Fully Featured FM Transmitter

Amplifiers

More Details

Similar Products
  • Lake People

G103-D-4

Lake People Phone-Amp G103D4 is a headphone amplifier intended for DANTE networks. The G103D4 model comes with a DANTE 4/4 input and two independent stereo amplifiers. 24 Bit / 192 kHz D/A converters with a Signal-to-noise ratio >105 dB and THD+N as low as 0,002 % are driving the powerful headphone amplifiers. These are best suited to drive any headphones from low to high impedance and with low or high sensitivity. To adapt the amp to demanding headphones, to further reduce the noise level or to maximize the travel of the volume control, the gain is internally adaptable by Dip-Switches to optimize the amp; The DANTE digital audio signals are input via a standard RJ45 connector. Lake People G103D4 will accept 4 audio channels. The unpacked audio signals are input to two high quality D/A converters. The recovered analogue signals are buffered, attenuated in the analogue domain and then sent to powerful headphone amplifiers. If required, additional gain of +6 dB or +12 dB can be set by Dip-Switches inside the amp. Each amp section offers a 1/4” and 3.5 mm phone jack which may be used simultaneously. Power supply for the amp is accomplished either by PoE (Power-over-Ethernet) or by a USB wall plug adaptor (not supplied) with USB-B or USB-C connector. The case, front and back panel of G103D4 is made of rugged black anodized aluminum, the lettering is laser engraved. The volume knobs are also made of solid aluminum.
    Amplifiers
  • Dante Ch: 4x0
  • 24-bit
See the product
mc2-audio-delta-100_1200px
  • MC2 Audio

MC2 Audio – Delta 80

Delta Series offers  the assurance of MC2’s highest quality audio power amp technology with future proofing via the inclusion of simple to use digital audio networking. Delta Series offers  the assurance of MC2’s highest quality audio power amp technology with future proofing via the inclusion of simple to use digital audio networking. A rear panel switch allows the amplifier to accept either four channels of analogue audio or pick up four channels of networked audio, via Dante, which is then converted using 24 bit 96kHz DACs. Connect to a Delta DSP amplifier using a single CAT5 cable to realise a stereo 4 way system with no further external processing required. Switch back to analogue to use as a powerful traditional quad channel amplifier. Run bridged channel pairs or link adjacent inputs for total flexibility in either analogue or digital mode.
    Amplifiers
  • Dante Ch: 4x0
  • 24-bit
See the product
210706-ma24lp2-persp1-7k_cut_low
  • Innosonix

Innosonix – MA24/LP²

The intention behind the Maxx series, which includes the LP², D² and HP² range, is to improve the total cost of ownership when it comes to a multi-channel solution. By offering the highest channel count per rack space in a single unit available on the market—complete with a comprehensive built-in DSP package—we believe we have achieved this intended goal.

Offering various audio-over-IP protocols, including Dante, combined with our industry-leading DSP capabilities (featuring 2048 taps of IIR/FIR filters, 32 points of parametric EQ, and precise delay and limiting per channel) provides integrators with the tools necessary to deliver a large loudspeaker solution with minimal sonic compromise.
The creative flexibility and improved cost performance of the Maxx series make these products extremely powerful tools.

MA24/LP² delivers 24×50W @4 Ω in only 1U of rack space.

    Amplifiers
See the product