Asystems – DMA8425D


Similar Products

  • Extron Electronics

NetPA U 4004 FX

The Extron NetPA U 4004 FX is a four channel, high performance Dante-enabled power amplifier with software configurable outputs that can simultaneously drive 8 ohm, 4 ohm, 70V, or 100V loads in multi-zone systems. For maximum flexibility, the total power of two adjacent 400 watt channels is shared, delivering up to 800 watts per single channel, according to system requirements. With its integrated DSP, the NetPA U 4004 FX includes essential signal processing for complex, decentralized systems while AES67 support ensures compatibility with other network audio devices. This Ecofficient Level 2 design features InstaWake, the ability to go from standby to full power in under 50 milliseconds. The fan cooled 1U enclosure does not require empty rack spaces for ventilation and includes front and rear rack mount hardware for stability.
    Amplifiers
  • 24-bit
  • 48kHz
Four_Audio_-_PPA_2200-2_0|Four_Audio_-_PPA_2200-2_0
  • Four Audio

Four Audio – PPA 2200-3

2200W three channel amplifier. The PPA series provides a high-quality DSP-powered amplifier solution for active loudspeakers. 2200W three channel amplifier. The PPA series provides a high-quality DSP-powered amplifier solution for active loudspeakers. It features Pascal high-power modules, analog, digital and Dante inputs and is available in different configurations for various kinds of speakers. Signal processing is done in 24 bit floating point on an Analog Devices Sharc DSP and uses dual range ADC for high dynamic input range.
    Amplifiers
glensound-athens2
  • Glensound

Glensound – Athens 2

Athens 2 is twin stereo phono preamplifier with excellent RIAA equalisation suitable for both moving magnet and moving coil turntable cartridges. It has redundant network circuits with 2 x copper & 2 x SFP interfaces. Athens 2 is twin RIAA phono preamplifier with Dante® and AES67 network audio outputs. It is a mains powered device with two high quality stereo turntable preamplifiers inputs. Each preamplifier has its own set of preset controls to allow accurate matching of the Athens 2 input circuitry to the turntable's cartridge. Input gain, input impedance and input capacitance can all be set for each of the two stereo inputs.The Athens 2 is suitable for use with both moving coil and moving magnet cartridges. To provide the best possible equalisation of the RIAA curve the preamps feature high quality high tolerance analogue circuitry followed by a high quality analogue to digital converter and DSP. The combination of the analogue circuitry and DSP provides a very good quality RIAA equalisation resulting in a very flat output.
    Amplifiers
  • Dante Ch: 2x2
  • 24-bit