SoundTube’s new IPD Hub 2 Extender Box for adding onto a Hub 2 local system. Connect up to 5 IPD Hub 2 amplifiers to an extender box. The IPD Hub 2 utilizes a Dante infrastructure for flexible audio distribution. The amp is complete with local and Dante inputs and local and network control to address requirements for commercial audio connectivity in numerous scalable systems such as retail, bar, restaurants, hospitality, spas, education facilities, and more.
BR-102D is a Dante interface with 12 microphone inputs . It is ideal for adding microphone inputs to Dante systems. The BR-102D can be installed near the sound source to minimize analog wiring that is prone to interference. Dante connection simplifies the system's infrastructure wiring. Each BR-102D unit can be connected to a network switch using a category 5 network cable. All adjustable parameters of BR-102D can be controlled by dante controller software. The BR-102D has 12 balanced microphone inputs. Each microphone input comes with a 48v phantom power switch that can independently switch phantom power. Each channel independently displays the channel level, and has an independent switch to adjust the input microphone volume. The front panel has indicators to show the power and network status for easy troubleshooting.
Ostrich series of products is an audio interface device based on Dante international general protocol. It can realize analog audio signal input, convert to digital audio signal output, route to any Dante audio transmission network device by Dante protocol, and realize high quality, long distance and low delay signal transmission. It supports the access of any Dante network digital audio, which can be converted into analog audio signal output, and can be connected to traditional analog audio devices such as mixer, power amplifier, processor and so on. The device uses high quality AD/DA signal conversion chip, provides 48 V of phantom power supply, and can access higher quality capacitive microphone.
The DIO1600 is a Dante enabled interface converting sixteen analogue line level inputs and sixteen analogue line level outputs to the audio network. All inputs and outputs have adjustable gain from +12dB to -12dB. The XLR version may be specified with XLRs on the front, network connections on the rear or XLRs on the rear, network connections on the front. It can also be supplied in a 1RU format with Tascam standard audio connections similar to the DIO1616MA below. Network connections may be copper and/or fibre via two SFPs and the unit includes secondary ports for network redundancy. The DIO1600 is PoE enabled so may be operated without a mains supply if required. The unit also has a 100-240V AC mains inlet and also supports 12 volt operation so may be effectively used with a redundant power supply. All level controls are adjusted using the built in web server. The unit will operate at sample rates of 48kHz and 96kHz and may also be used in AES67 mode.
