Allen & Heath - Dante 128x128

Allen & Heath – Dante 128×128

Product Information

The Dante 128×128 card offers low latency, high channel count connectivity between dLive systems and Dante networks and devices. With 128 channels of bidirectional audio at 96kHz, the card allows high channel digital splits between systems whilst offering simultaneous multitrack recording of up to 64 channels via Dante Virtual Soundcard.The front panel Primary and Secondary ports allow simultaneous connection to multiple Dante devices, or dual-cable redundancy with compatible hardware. A dedicated Control Network port is provided for configuration using Dante Controller software.Features

Specifications

Dante Ch: 128x128
Bit Depth: 24-bit
Sample Rate: 48kHz, 96kHz
AES67 Enabled

Cloud – CA Series Dante Cards

Cloud's CA Series Dante Cards are available in three models - CDI-CA2, CDI-CA4, and CDI-CA8

Features:

• 2, 4, and 8-channel Dante input option cards

• Support for 44.1kHz, 48kHz, 88.2kHz and 96kHz sample rates

• Dante AES67 interoperability mode

• 1Gbps Ethernet (CDI-CA8) or 100Mbps Ethernet (CDI-CA2 / CDI-CA4)

• Dante redundancy or Ethernet switch modes (CDI-CA8)

• Dante Domain Manager (DDM) ready

Dante Interface Cards

See the product

MONISMS

MONISMS – MNS-AMPMC230POE

The POE DANTE/AES67 Audio Amplifier module MNS-AMPMC230POE, Built-in to your 4-8 ohm speaker, that instantly Dante-enables your speakers. The POE DANTE/AES67 Audio Amplifier module MNS-AMPMC230POE, Built-in to your 4-8 ohm speaker, that instantly Dante-enables your speakers. The MONISMS Dante Audio Amplifier is a compact power amplifier module that drives small 4-8Ω speakers. The MONISMS Dante Amplifier has two outputs, each with 15W of power into an 4-8Ω load, This makes the module ideal for powering small areas consisting of only a few low power speakers. The module's audio input is via an Ethernet audio network, allowing the use of the DANTE/ AES67 audio network protocol. MNS-AMP230POE is powered by standard POE+ and has a MAX power of 30 watts [2*15W]. If there is not POE+ used, It can used the external 24VDC power supply.

Dante Interface Cards

See the product

DiGiCo

DiGiCo – DMI-DANTE64@96

The DiGiCo DMI-DANTE64@96 allows 64 channels in and 64 channels out at both 48kHz and 96kHz. It has a Primary and a Secondary port, both of which are Ethercon ports, and an RJ45 Control port. The card has two modes that can be changed in Dante Controller. In Switched Mode, the three ports are switched together. In redundant mode, the Control and Primary ports shall be switched together and work as a redundant pair with the Secondary port, each having separate IP addresses so that if the primary connection fails, the secondary connection will take over.

Dante Interface Cards

Dante Ch: 64x64
16-bit, 24-bit, 32-bit

See the product

Allen & Heath – Dante 128×128

Product Information

Specifications

Similar Products

Cloud – CA Series Dante Cards

MONISMS – MNS-AMPMC230POE

DiGiCo – DMI-DANTE64@96

Stay connected to Dante

Support

Company

Dante Networking Alliance