Ghielmetti – GMS 3164 Dante


More details

Similar Products

a164dwall
  • DiGiCo

DiGiCo – A164D Wall LCD

The A164D Wall LCD is a 16 input 4 output I/O Expander that uses the Dante network protocol to provide fixed, additional I/O anywhere on a network and is designed for wall or floor mounting. It comes with 16 Mic Preamps on XLR inputs with Phantom Power status LEDs and four XLR Line Outs with direct preamp control from the 4REA4 controller software. It can run at both 48K and 96k sample rates and it is AES67 compatible. Primary and secondary Dante ports come with locking EtherCON connectors and can run in both redundant and switched mode. All LCD labels are dimmable and can be customised using Dante controller software.

    I/O Interfaces
  • Dante Ch: 20x16
  • 24-bit
proco-aodom-2
  • ProCo

ProCo – AoD-FAN3-2XM

The AoDoM 2 channel provides one RJ45 Dante input and two Neutrik NC3MXX-BAG series black XLR analog outputs. Using our rugged aluminum extrusion channels and hand soldered, 3 ft. analog audio tails, ProCo AoDoM modules provide simple connection of analog equipment to a Dante network and provide studio-quality, low-latency audio via the XLR connectors. Comaptible with any Dante ecosystem and provides line level analog audio signal to output devices. 

  • Dante audio input
  • Two channels of analog output
  • Rugged aluminum extrusion housing
  • resilient cable strain relief
  • Neutrik black XLR connectors
  • 3 ft. ProCo MIC3 balanced cable with braises shielf
  • RJ45 metal connector with integrated LED's
  • 1 year limited warranty
    I/O Interfaces
avn-ai16-iso-square
  • Sonifex

Sonifex – AVN-AI16 16 Input Dante® Interface, PoE

The AVN-AI16 audio converter and interface converts up to sixteen analogue inputs to the Dante Audio-over-IP networking standard. This cost effective 1U rack-mount unit offers an easy solution for AV professionals and system integrators. It is simple to configure and operate, with all set-up, except line-up levels, done via the standard Dante Controller software and power via PoE (Power Over Ethernet).

All analogue inputs are on high-quality Neutrik XLR connectors and there are front panel status/confidence LEDs for PoE, Link, and Clock. Global 0dBFS line-up can be set to +12dBu, +18dBu or +24dBu to meet your specific requirement via the front panel recessed toggle switch.

    I/O Interfaces
  • Dante Ch: 0x16
  • 16-bit, 24-bit, 32-bit